2.3. Listing iSCSI Targets¶
Using the vstorage-iscsi list
command, you can list all iSCSI targets registered on a node or display detailed information about a specific iSCSI target on a node.
To list all iSCSI targets registered on a node, run the command as follows:
# vstorage-iscsi list
IQN STATUS LUNs HOST PORTAL(s)
iqn.2014-04.com.vstorage:test1 running 1 fefacc38a2f140ca 192.168.10.100
iqn.2014-04.com.vstorage:test2 running 1 fefacc38a2f140ca 192.168.10.101
iqn.2014-04.com.vstorage:test3 stopped 1 fefacc38a2f140ca 192.168.10.102
iqn.2014-04.com.vstorage:test4 stopped 0 fefacc38a2f140ca 192.168.10.103
To display detailed information about an iSCSI target registered on a node, run the vstorage-iscsi list
command with the target’s name as the option. For example:
# vstorage-iscsi list -t iqn.2014-04.com.vstorage:test1
Target iqn.2014-04.com.vstorage:test1:
Portals: 192.168.10.100
Status: running
Registered: yes
Host: fefacc38a2f140ca
LUN: 1, Size: 102400M, Used: 1M, Online: Yes
The command outputs above show the following data:
Item | Description |
---|---|
Target | Unique alphanumeric name of the iSCSI target. |
Portals | Target’s IP address(es). |
Status | Target’s current state.
|
Registered | Whether or not the target is registered on the host which ID is shown in the Host entry. |
Host | Acronis Storage node ID. |
LUN | Virtual disk’s integer number within the target. |
Size | Virtual disk’s logical size (16 TB maximum). |
Used | Virtual disk’s physical size. The physical size can be smaller than logical due to the expanding format of the virtual disk. |
Online |
|
Jan 15, 2019