3.3. Connecting Cables to Acronis Cyber ApplianceΒΆ
Note
For more details on configuring the network infrastructure, see the Installation Guide.
To prepare Acronis Cyber Appliance for configuration, do the following:
Connect the appliance to the electrical outlets by using the supplied power cables.
On every node, connect any SFP+ or RJ45 network port (1 on the diagram) to a switch (2 on the diagram) with access to a dedicated subnet for your infrastructure. Then, connect the admin laptop (3 on the diagram) to the same switch. The diagram below shows an example of the cable connection.
Important
The nodes have preconfigured IP addresses: 10.20.20.11 to 10.20.20.15.
(Optional) Connect the out-of-band management network interfaces of each node and the chassis (1 on the diagram) to a switch with access to the IPMI subnet for your appliance (2 on the diagram). The nodes have preconfigured IPMI IP addresses: 10.20.30.11 to 10.20.30.15. The chassis has the preconfigured IPMI IP address 10.20.30.10. Connect the admin laptop (3 on the diagram) to the same switch.